5.4 Triton

Discussion of all other Fords, Mustangs, F150s etc.

Moderator: MalcolmV8

Post Reply
User avatar
Grumpy
Posts: 325
Joined: Wed Nov 05, 2008 10:48 am
SM: No
Location: Oxford, Miss
Contact:

5.4 Triton

Post by Grumpy »

is there a 5.4 Triton discussion page on this forum?if not thats ok ill look elsewhere to see if i can find one ..............my dads 1997 F150 locked up-and was needing some advice on if the 5.4's are a bad design or what to cause it to lockup as i have seen like 15 to 18 in the past week or so that have been locked up due to metal shavings in the oil pan and was just wondering if this was a problem or not.........thanks in advance


Peace
96 Ranger Extended cab - work in progress.. 5.0 out of a 90 Mustang GT..Tremec TKO-3550-2 with mid-shift conversion ..Explorer GT40 intake and fuel rails. X303 FMS cam . WP Jr alum heads . K&N air filter.lowered .Weld Drag Lites (or Weld Pro-Stars) .. a 8.8 with Auburn Pro ..Moser custom alloy street axles (31 spline) and a 3:73 gear.L&L engine mounts and oil filter adapter.Aluminum Rad from James Duff.



Peace from Oxford Miss.
Grumpy
User avatar
MalcolmV8
Supporting Member
Posts: 2597
Joined: Fri Dec 10, 2004 4:50 pm
SM: Yes
Location: Kansas City, MO

Re: 5.4 Triton

Post by MalcolmV8 »

There is no Triton specific forum on here but you can use the Ford Performance forum we have on here for all other vehicles and general engine questions etc.
92 302 Ranger - sold
94 302 Ranger AWD - sold
07 BMW 335xi - tuned, boost turned up, E85 - sold
04 911 TT - to many mods to list. Over 600 All Wheel HP on pump gas - sold
2015 Coyote - daily driver
03 Cobra - 2.3 TVS on a built 12:1 CR motor with ported heads, cams, long tubes etc.
MD Racing Lean Protection Module
E85

Tuned by MD Racing

https://www.youtube.com/c/MalcolmV8
User avatar
cgrey8
Supporting Member
Posts: 4055
Joined: Fri Dec 10, 2004 8:23 pm
SM: No
Location: Acworth, Ga (Metro Atlanta)
Contact:

Re: 5.4 Triton

Post by cgrey8 »

As admin, you can just move the thread over to that forum.
...Always Somethin'

89 Ranger Supercab, 331, ported GT40p heads w/1.6RRs, Crane Powermax 2020 cam, ported Explorer lower, FMS Explorer (GT40p) headers, aftermarket T5 'Z-Spec', 8.8" rear w/3.27s, Powertrax Locker, A9L w/Moates QuarterHorse, Innovate LC-1, James Duff traction bars, iDelta DC Fan controller

Admin of EECtuning.org
User avatar
Grumpy
Posts: 325
Joined: Wed Nov 05, 2008 10:48 am
SM: No
Location: Oxford, Miss
Contact:

Re: 5.4 Triton

Post by Grumpy »

ok ....... ty .. i didnt know where to put it at so i put it where it would at least been seen then moved to where it needed to go ..... thanks guys Peace
96 Ranger Extended cab - work in progress.. 5.0 out of a 90 Mustang GT..Tremec TKO-3550-2 with mid-shift conversion ..Explorer GT40 intake and fuel rails. X303 FMS cam . WP Jr alum heads . K&N air filter.lowered .Weld Drag Lites (or Weld Pro-Stars) .. a 8.8 with Auburn Pro ..Moser custom alloy street axles (31 spline) and a 3:73 gear.L&L engine mounts and oil filter adapter.Aluminum Rad from James Duff.



Peace from Oxford Miss.
Grumpy
User avatar
MalcolmV8
Supporting Member
Posts: 2597
Joined: Fri Dec 10, 2004 4:50 pm
SM: Yes
Location: Kansas City, MO

Re: 5.4 Triton

Post by MalcolmV8 »

cgrey8 wrote:As admin, you can just move the thread over to that forum.
I did but I had it leave a shadow (as they call it) in the other forum. Basically just a link to the thread on the correct forum.
92 302 Ranger - sold
94 302 Ranger AWD - sold
07 BMW 335xi - tuned, boost turned up, E85 - sold
04 911 TT - to many mods to list. Over 600 All Wheel HP on pump gas - sold
2015 Coyote - daily driver
03 Cobra - 2.3 TVS on a built 12:1 CR motor with ported heads, cams, long tubes etc.
MD Racing Lean Protection Module
E85

Tuned by MD Racing

https://www.youtube.com/c/MalcolmV8
Post Reply