V8-Ranger.com

What did you guys do to solve the problem with the vip self test wire. C-110 T/LG in the 5.0 mustang harness to ???? is my problem. I think it has to come in contact with the fuel relay somehow. any help with this thanks alot regards

I have to move this back. The drivers side header runs into it, I want to go just behind the fuel filter on the chassis. Its a 96 reg cab. Its gonna be two brake lines and the elec connection. I want to know if anybody sees a possible break issue with this thanks for your thoughts.

Ok thanks guys. i got tired of fooling around with what i have and wasting time. I'm gonna mock this whole thing up, pull the motor then pull the cab off to do some chassis work. thanks for the help. They are to arrive on 3/5. Ill keep you updated.........

just called for the L&L mounts. I just want to drop this in and set the location for the trans and go. You guys that have used them can i get the motor back as far as I can with these mounts any other problem you can think of thanks....,.,.

Hi guys Im looking into doing a swap to a 96 ranger 2wd automatic trans std cab. I would like to know your choice in motor mounts and any problems with that trans(4r70w). Im trying sort out the placementof the engine and tranny now. I just started the install and hope your follow the build thanks fo...

Ok grey thanks Bauman box is the way I'll go thanks for the reply.

Hi guys its been a long time. I got the bug again when I help'd a friend do a 5.3 in a sonoma.so I found a real clean 96 splash 3.0 with automatic trans. I have a 4r70w trans from another project that I would like to use. Now all of my old stuff is for a manual T5 with the computer from a 90 5.0. My...

Ok thanks I'll try the photobucket.

I'm going to start my project soon,and hopefuly it will carry through the winter. I would like to share the project with you and post pics. I have a digital camera and would like to know the easiest way to post them here. Thank you for your help.

I found a clean 99 2wd auto 4cyl s10. it needs my 5.0 in it. So this fall ill give it a try. some points of concern are, I have a 90 manual computer and wiring harness I'll have to switch. I see Malcolm used a 40rw with a bauman controller, this is a option. The wiring should be fun GM dont do the e...

Malcolm whats the power when it starts to fail. Input to the o2's Does the 12vdc change as well.

Malcolm this is a reach but swap the ecm from the red truck to the blue and check your HEGO's again. Just a thought......

That wire is grounded to my firewall. It does have the ring and needs ground.

I had this problem for about a year. It ended up being a voltage problem to the computer. The voltage was to low. The ACT and ECT are a good start.

Your Right Sorry I forgot about you guys trying to use P heads. My fault.